Home / Product
Contact Us

Dalian Huawei Bearing Manufacturing Co., Ltd
Add.: Zone B, Sun Industrial park, Wafangdian, China
Mobile:139 4266 7702
TEL:0411-66516501 66516503
FAX:0411-66516502
MAIL:manager@lrb-bearing.cn
Q Q:821661939

Product

Details:

It can withstand both radial and axial loads. Can work at higher speeds. The larger the contact angle, the higher the axial load carrying capacity. High precision and high speed bearings typically take a 15 degree contact angle. Under the axial force, the contact angle will increase. Single row angular contact ball bearings can only withstand axial loads in one direction and will cause additional axial forces when subjected to radial loads. And can only limit the axial displacement of the shaft or housing in one direction. Angular contact ball bearings have a contact angle of 40 degrees and can withstand large axial loads. Angular contact ball bearings are non-separable designs with different shoulder heights on the sides of the inner and outer rings.
In order to increase the bearing capacity of the bearing, the shoulder on one side is machined lower, so that the bearing can be loaded with more steel balls.
Characteristic
1. The universal matching bearing
The universal matching group is specially processed. When the bearings are installed close to each other, any combination can achieve the established internal clearance or preload, and the average load distribution without using the pad. Tablet or similar device. Paired bearings are used when there is insufficient load carrying capacity of a single bearing (using a coupling configuration) or when subjected to a combined load or axial load acting in both directions (using a back-to-back or face-to-face configuration).
2, The basic design of the bearing (can not be used as a universal matching), for the configuration of a single bearing basic design of the single row angular contact ball bearing is mainly used in each position only one bearing configuration. Its width and amount of protrusion are normal tolerances. Therefore, it is not suitable to install two single-row angular contact ball bearings.